ALLNET Novedades
Fanless 4-port Gigabit full managed industrial PoE Layer 2+ Ethernet switch compliant with IEEE802.3at
|
Model |
ALL-SGI8104v2PM |
Copper Ports |
4-10/100/1000BASE-T RJ45 auto-sensing ports |
Fiber Ports |
2-100/1000BASE-T SFP interfaces, supports 100/1000Mbps dual mode |
PoE Ports |
4-802.3af/802.3at PoE Injector Ports |
Console Ports |
1 x RS-232-to-RJ45 serial port (115200, 8, N, 1) |
Switch Architecture |
Store-and-Forward |
Switch Fabric |
12Gbps/non-blocking |
Throughput |
8.928Mpps @64 bytes |
Address Table |
8K entries |
Share Data Buffer |
4.1 Mb |
Jumbo Frame |
9216 Bytes |
SDRAM |
1Gb |
Flash Memory |
128Mb |
Flow Control |
IEEE 802.3x pause frame for full-duplex ; Back pressure for half-duplex |
Reset Button |
>2 sec.: Factory default and reset |
Power Supply |
48 ~ 57 VDC, 50/60Hz,Dual DC for PoE support 12VDC ~ 48VDC for non PoE support |
PoE Standards |
IEEE 802.3af Power over Ethernet/PSE IEEE 802.3at Power over Ethernet Plus/PSE
|
PoE Power Supply Type |
Per Port 52V DC, 300mA. Max. 15.4 watts (IEEE 802.3af) Per Port 52V DC, 600mA. Max. 30 watts (IEEE 802.3at)
|
LED Indicators |
Power: Green Solid on?power work normal,off?power disconnected
System:Green
Blink?work normally, solid on?soft work abnormal, fast blink?soft upgrade
PoE: Yellow
Solid on?PoE work normally, Off?PoE doesn?t work, Blink?PoE overload
10/100/1000T RJ45 Interfaces (Port 1 to Port 4): 1000 LNK/ACT (Green),
Blink?port connected with data transmission;
Solid on?port connected without data transmission
100/1000Mbps SFP Interfaces (Port 5 to Port 6): Green
Blink- port connected with data transmission;
Solid on- port connected without data transmission
|
EMC |
Surge Immunity:6KV Per: IEC61000-4-5 ESD Protection: ESD Level 4 Per: IEC61000-4-2;EFT Level 4 Per: IEC61000-4-4
|
Dimension |
145x112x47.2mm |
Weight |
0.6kg |
Working Temperature |
-40°C to 75°C |
Storage Temperature |
-40°C to 80°C |
Operation Humidity |
5% to 95%, non-condensing |
MTBF |
50,000hrs |
Layer 2 functions
Port configuration |
Auto-negotiation Flow Control
Port Mirror: TX/RX/BOTH; Many-to-1 monitor
CPU Mirror
Traffic statistics
|
Link Aggregation |
Static link aggregation LACP(Dynamic Trunk/Static Trunk)
Algorithm based on Source/Destination MAC
Algorithm based on Source/Destination IP
|
MAC Table |
Aging Time Static MAC address
Dynamic MAC address management
|
VLAN |
4094 Active VLANs 4094 VID
802.1Q Tag VLAN
Port VLAN
Protocol VLAN
MAC VLAN
Voice VLAN
802.1ad Q-in-Q tunneling
Private VLAN (Protected port)
GARP/GVRP
|
ACL |
256ACLs L2, L3 e L4
Time-based ACL
IP ACL
MAC ACL
MAC-IP ACL
User-Defined ACL
ICMPv6
|
Spanning tree |
802.1D Spanning Tree Protocol (STP) 802.1w Rapid Spanning Tree Protocol (RSTP)
802.1s Multiple Spanning Tree Protocol (MSTP)
Loop Guard
Root Guard
TC-BPDU Guard
BPDU Guard
BPDU Filter
|
Ring Protection |
<20ms G.8032 ERPS Ring Fast Ring
ALLNET Ring, < 20ms
|
Multicast |
256 groups IGMP v1/v2/v3 Snooping, Fast Leave
MLD Snooping
Multicast VLAN
IGMP filter
MVR
Multicast Routing
|
QOS |
8 mapping IDs to 8 level priority queues CoS port-based
CoS 802.1p-based
CoS DSCP-based
Scheduling algorithms SP, WRR, SP+WRR
Storm Control (Broadcast, Multicast, Unknown Unicast)
Bandwidth control per port
SWRR, DWRR for Scheduling
Flow Redirect
Precedence
TOS
Rate Limiting(Ingress/Egress)
Stri Priority
|
Security Features |
Port Security MAC address filter
ARP Association (Manual, ARP scanning, DHCP snooping)
ARP Protection
AAA
DAI
DoS (Denial of Service)
Classification of packages based on: End.MAC, IP End, TCP / UDP Ports,
Protocol Type;
802.1x Authentication (port-based e MAC-based)
TACACS/TACACS+ Authentication
RADIUS Authentication
DHCP Filter
Guest VLAN
SSLv2/SSLv3/TLSv1
SSHv1/SSHv2
Restriction of WEB access based on: IP Address, And. MAC and Port;
Port Isolation
Loopback detection
|
Management |
SNMP v1/v2c/v3 with Full Private MIBs RMON 4 groups
WEB (HTTP/HTTPS)
CLI (Telnet, Console, SSHv1/v2)
Firmware upgrade via console/web/TFTP
Configuration Backup/Reload
Dual Firmware
LLDP
Configuration Export/Import
CDP Aware
OAM (IEEE802.3ah)
CFM (IEEE802.1ag)
sFlow
Telnet Client
|
Synchronization, IEEE1588
|
Support IEEE1588v2 transparent clock |
Other Features |
DNS Client DHCP Relay
DHCP Client
DHCP Snooping
DHCP Option 66
DHCP Option 67
DHCP Option 82
NTP/SNTP Client
UPNP
UDLD
|
PoE management |
Total PoE power budget control Per port PoE function enable/disable
PoE admin-mode control
PoE port power feeding priority
Per PoE port power limitation
PD classification detection
PD alive check
PoE schedule
Soft-reboot PoE Non-stop
|
Maintenance |
Cable Diagnostics Ping
SFP DDM (Digital Diagnostics Monitoring)
Thermal protection
System log (Local and Remote)
Memory and CPU Monitoring
Tracert/ Tracert 6
|
Layer 3 functions
Static Routing |
IPv4 Unicast: Static Routing (Software Base) IPv6 Unicast: Static Routing (Software Base)
|
IPV6 |
IPv6 neighbor discovery (ND) Path maximum transmission unit (MTU) discovery
Internet Control Message Protocol (ICMP) version 6
TCPv6/UDPv6
Ping6
Telnet(v6)
Http/Https
Interface IPV6
ACL IPV6
|
Back