ALLNET Power over Ethernet Switches
Each Allnet PoE switch has after the standard IEEE 802.3af PoE on port outputs with 15.4 watts, the most switches in addition to IEEE.3at up to 30 watts per port. Depending on the PoE overall performance of the device.
An overview of all our PoE switches with the respective features, please click here: DOWNLOAD
PoE cascading between the PoE switches is possible.
Unmanaged PoE Switches
Smart Managed Switches
Full Managed Switche Layer2+
Fanless 8-port Gigabit PoE Layer 2 Ethernet switch compliant with IEEE802.3at with 130W PoE budget ALL-SG8610PM
|
Model
|
ALL-SG8610PM
|
Copper Ports
|
8-10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports
|
Fiber Ports
|
2x1G BASE-X SFP interfaces, supports 100M/1G Mbps dual mode
|
PoE Ports
|
1~8-802.3af/802.3at PoE Injector Ports
|
Console Ports
|
1 x RS-232-to-RJ45 serial port (115200, 8, N, 1)
|
Switch Architecture
|
Store-and-Forward
|
Switch Fabric
|
20 Gbps/non-blocking
|
Throughput
|
14.88Mpps @64 bytes
|
Address Table
|
8K entries
|
Share Data Buffer
|
4 Mb
|
Jumbo Frame
|
9600 Bytes
|
SDRAM
|
1Gb
|
Flash Memory
|
128Mb
|
Flow Control
|
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
|
Reset Button
|
>2 sec.: Factory default and reset
|
Power Supply
|
100~240V AC, 50/60Hz, 4A (max.)
|
Power Consumption
|
Max.150 watts/1122 BTU
|
PoE Standards
|
IEEE 802.3af Power over Ethernet/PSE
IEEE 802.3at Power over Ethernet Plus/PSE
|
PoE Power Supply Type
|
Per Port 52V DC, 300mA. Max. 15.4 watts (IEEE 802.3af)
Per Port 52V DC, 600mA. Max. 30 watts (IEEE 802.3at)
|
PoE Budget |
130W |
LED Indicators
|
Power: Green
Solid on- power work normal, off- power disconnected
System: Green
Blink -work normally, solid on- soft work abnormal, fast Blink ? soft upgrade
PoE: Yellow
Solid on- PoE work normally, Off- PoE doesn?t work, Blink - PoE overload
10/100/1000T RJ45 Interfaces (Port 1 to Port 8): 1000 LNK/ACT (Green) Blink - port connected with data transmission; Solid on- port connected without data transmission
100/1000Mbps SFP Interfaces (Port 9 to Port 10): Green
Blink - port connected with data transmission; Solid on- port connected without data transmission
|
EMC
|
Surge Immunity:
4KV Per: IEC61000-4-5
ESD Protection:
ESD Level 4 Per: IEC61000-4-2
EFT Level 4 Per: IEC61000-4-4
|
Layer2 Functions |
|
Port configuration
|
Auto-negotiation Flow Control
Port Mirror: TX/RX/BOTH; Many-to-1 monitor
CPU Mirror
Traffic statistics
|
Link Aggregation
|
Static link aggregation
LACP(Dynamic Trunk/Static Trunk)
Algorith based on Source/Destination MAC
Algorithm based on Source/Destination IP
|
MAC Table
|
Aging Time
Static MAC address
Dynamic MAC address management
|
VLAN
|
4094 Active VLANs
4094 VID
802.1Q Tag VLAN
Port VLAN
Protocol VLAN
MAC VLAN
Voice VLAN
802.1ad Q-in-Q tunneling
Private VLAN (Protected port)
GARP/GVRP
|
ACL
|
256ACLs
L2, L3 e L4
Time-based ACL
IP ACL
MAC ACL
MAC-IP ACL
User-Defined ACL
ICMPv6
|
Spanning tree
|
802.1D Spanning Tree Protocol (STP) 802.1w Rapid Spanning Tree Protocol (RSTP) 802.1s Multiple Spanning Tree Protocol (MSTP)
Loop Guard Root Guard TC-BPDU Guard
BPDU Guard BPDU Filter
|
Ring Protection |
<20ms G.8032 ERPS Ring
Fast Ring
|
Multicast |
256 groups
IGMP v1/v2/v3 Snooping, Fast Leave
MLD Snooping
Multicast VLAN
IGMP filter
MVR
Multicast Routing
|
QOS
|
8 mapping IDs to 8 level priority queues
CoS port-based
CoS 802.1p-based
CoS DSCP-based
Scheduling algorithms SP, WRR, SP+WRR
Storm Control (Broadcast, Multicast, Unknown Unicast)
Bandwidth control per port
SWRR, DWRR for Scheduling
Flow Redirect
Precedence
TOS
Rate Limiting (Ingress/Egress)
Stri Priority
|
Security Features
|
Port Security
MAC address filter
ARP Association (Manual, ARP scanning, DHCP snooping)
ARP Protection
AAA
DAI
DoS (Denial of Service)
Classification of packages based on: End.MAC, IP End, TCP / UDP Ports, Protocol Type;
802.1x Authentication (port-based e MAC-based)
TACACS/TACACS+ Authentication
RADIUS Authentication
DHCP Filter
Guest VLAN
SSLv2/SSLv3/TLSv1
SSHv1/SSHv2
Restriction of WEB access based on: IP Address, And. MAC and Port;
Port Isolation
Loopback detection
|
Management
|
SNMP v1/v2c/v3 with Full Private MIBs
RMON 4 groups WEB (HTTP/HTTPS) CLI (Telnet, Console, SSHv1/v2) Firmware upgrade via console/web/TFTP
Configuration Backup/Reload
Dual Firmware
LLDP Configuration Export/Import CDP Aware
OAM (IEEE802.3ah) CFM (IEEE802.1ag) sFlow
|
Synchronization, IEEE1588
|
Support IEEE1588v2 transparent clock
|
Other Features
|
DNS Client DHCP Relay DHCP Client DHCP Snooping DHCP Option 66 DHCP Option 67 DHCP Option 82 NTP/SNTP Client
UPNP
UDLD
|
PoE management
|
Total PoE power budget control
Per port PoE function enable/disable PoE admin-mode control
PoE port power feeding priority Per PoE port power limitation
PD classification detection
PD alive check PoE schedule
Soft-reboot PoE Non-stop
|
Maintenance
|
Cable Diagnostics
Ping
SFP DDM (Digital Diagnostics Monitoring)
Thermal protection
System log (Local and Remote)
Memory and CPU Monitoring
|
Layer 3 functions |
|
Static Routing
|
IPv4 Unicast: Static Routing(Software Base)
IPv6 Unicast: Static Routing(Software Base)
|
IPV6
|
IPv6 neighbor discovery (ND)
Path maximum transmission unit (MTU) discovery Internet Control Message Protocol (ICMP) version 6
TCPv6/UDPv6
Ping6
Telnet(v6)
Http/Https
Interface IPV6
ACL IPV6
|
Dimension
|
280x213x44.5mm
|
Weight
|
2 kg
|
Working Temperature
|
-10°C to 45°C
|
Storage Temperature
|
-20°C to 70°C
|
MTBF
|
50,000hrs
|
Back